
Panel User Guide Issue 1.4 4000 Digital Series II
Page 76 STA0380
NOTE: Microphone is shown here for illustrative purposes only. Contact Vitec Group Communications
for details of suitable products.
4.6.3 Microphone Socket
Insert the optional microphone into this socket. The detachable microphone is connected via a 3-pin
screw locking DIN connector.
4.6.4 Crosspoint Level Control
Each DAK has a corresponding pot switch, located directly above it. Switch operation is described in the
next section.
Turning a pot switch above a DAK, clockwise or counter-clockwise causes the cross-point level to
increase or decrease, respectively. The cross-point level indicator changes to indicate the new cross-
point level setting.
The pots also operate in SOFT mode, but there is no cross-point level indicator on the display.
4.6.5 Pot Switch Operation
A pot switch, on the PD4212 and PD4222 panel types, operates on the same port as the corresponding
LCD key. However, pressing a pot switch can only make listen routes.
In this mode, a pot switch configuration is assumed from the corresponding LCD key in accordance with
the following rules:
i) CMAPS configuration data is copied from the LCD key to the pot switch (excluding DCC program-
ming) provided that there is no protection on listen access to the port,
Consult the Vitec Group Communications Installation Guide for fur-
ther details.
Contact Vitec Group Communications for suitable Microphone
options.
Vitec Group Communications can offer three different types type of
microphones - 100mm, 340mm and 490mm goosenecks.
All panels are available with XLR 5 or DIN 5 headset connection.
Kommentare zu diesen Handbüchern