
4 Table of Contents / Specifications
Specifications subject to change without notice or obligation.
TABLE OF CONTENTS
2 Caution Statements
3 Important Safety Instructions
4 Table of Contents / Specifications
5 Purpose
6 General Description & Installation
7 Additional System Components
8 Front Panel Controls & Connections
9 Rear Panel Controls & Connections
SPECIFICATIONS for SRR60 and related system components
10 BP60 Belt Pack Controls & Connections
11 HHM60 Microphone Controls & Connections
12 Battery installation & Charging
13 Daily Operation
16 General Usage Tips
17 Troubleshooting Guide
18 Service / If you Need To Call For Help
19 Warranty
Inputs:
IR Microphone Channels:
AUX Input, RCA jacks, front:
AUX Input, 3.5mm jack, front:
AUX Input, 3.5mm jack, rear:
3 Band Equalizers:
MIC Channel A:
MIC Channel B:
AUX1, AUX2 combined:
Volume Controls, front panel:
MIC, Channel A:
MIC, Channel B:
AUX 1:
AUX 2:
AUX 3:
MASTER VOLUME (speakers):
Outputs:
Speaker, rear panel terminals:
Line level AUX, front panel:
Line level AUX, rear panel:
Volume Controls,
recessed screwdriver set:
Trim for each speaker output:
Trim for each AUX Line output:
Amplifier Output Power:
Total Harmonic Distortion (THD):
Output Impedance, speaker outputs:
Receiver Frequency Response:
Remote IR pickup sensor inputs:
Speaker Muting:
Safety :
FCC:
5 total
2 (CH A and CH B)
1
1
1
3 sets
1
1
1
6
1
1
1
1
1
1
6
4 sets
1
1
6
4
2
60 W maximum @ <10%
THD (15W nominal per
speaker output)
< .5 %, 1 kHz, .01 to
10 W/ CH into 8 ohms
8 ohms, nominal
20 Hz to 20 kHz
3 (1, 2, or 3 may be
used depending on
room size and dimensions.)
Contact Closure and
Audio Sensing Inputs
Safety certified to
ANSI/UL 60065, 7th ed.
dated 6/30/04, rev
11/20/06
CAN/CSA-C22.2 No.
60065:03 (2006)
Part 15 B
SRR60 RECEIVER
HHM60 HAND HELD MICROPHONE
Channels:
IR Subcarrier Frequencies:
Battery Current:
Battery Type:
(2 used)
Charging Time:
Microphone Gain:
2 user selectable
CH 1 - 2.06 MHz
CH 2 - 2.56 MHz
mA low (LO): 100 mA
mA high (HI): 160 mA
AA, Ni-MH rechargeable,
minimum of 2000 mAH
Approx 12 - 14 hours to
charge depleted 2100 mAH
cells using supplied
charger.
User Adjustable - access
inside battery compartment
Channels:
IR Subcarrier Frequencies:
Battery Current:
Battery Type:
(2 used)
Charging Time:
Microphone Gain:
2 user selectable
CH 1 - 2.06 MHz
CH 2 - 2.56 MHz
mA low (LO) - 230 mA
mA high (HI) - 350 mA
AA, Ni-MH rechargeable,
minimum of 2000 mAH
Approx 12 - 14 hours to charge
depleted 2100 mAH cells using
supplied charger.
Set by factory
BP60 BELT PACK with EM60LAVALIERE MIC
SRR60 RECEIVER (Continued)
120 VAC, +/- 20 %
50/60 Hz / 150 W Max.
75 W nominal @ full output /
8 ohm speakers.
150 W during fault condition
such as shorted outputs.
Receiver Power Requirement:
Kommentare zu diesen Handbüchern